suggestions needed for ihp 35 .22

[lakecity_shooter]

After installing a cheap chinese scope i am in love with my IHP 35...........today while shooting when i closed the barrel it doesnt lock..........that ill get it done by tommorow by local gunsmith..i want to change the spring to increase the FPS !!!!!!!!!!!!!!


so plssssss suggest a gud spring and a source to obtain that ......i knew one gunshop in ratlam (M.P) where CHEEROKE springs were available......but i was late a they were all sold.................any suggestions to increasing the velocitiy would be highly appreciated.!!!!!

[ramtiger]

Install G smith spring and Diana washer

[pradeep.kumar]

Can you post the picture please. What scope is that?

[lakecity_shooter]

@ramtiger..please tell me the source to precure gsmith spring and diana washer ..

[mundaire]

If you think that you'll improve the performance of a springer simply by changing the spring to a stiffer one, you've been misinformed. One of my friend's had installed a JM spring on his IHP 35 many moons ago, while there was some increase in FPS, the airgun would shake loose all of its screws every few shots!

Read up a bit on the subject before doing any "tuning", plenty of information on the Internet, you should also consider picking up Airgun from trigger to target by GV Cardew and giving it a thorough read.

Cheers!
Abhijeet

[brihacharan]

If you think that you'll improve the performance of a springer simply by changing the spring to a stiffer one, you've been misinformed. One of my friend's had installed a JM spring on his IHP 35 many moons ago, while there was some increase in FPS, the airgun would shake loose all of its screws every few shots!

> I learned it the hard way.
> Please note that the internals of any Indian made AR eg: the design / dimensions / metallurgy etc. does not fully permit the installation of JM springs + kit. They are best suited to overseas made ARs.
> My sincere advice is that if your Indian made AR shoots at 590 / 600 fps & gives you 1/2" groups at 25yds (75ft) you got it made!
> Enjoy your shooting - Get accuracy consistently - That's it - nothing more - nothing less
> Like my Grandpa used to say "Son, if you can consistently hit an egg at 30 paces - You got meat on the table"!!!
Cheers
Briha

[pradeep.kumar]

To my understanding what Abhijeet and Briha says makes a lot of sense.

Like my Grandpa used to say "Son, if you can consistently hit an egg at 30 paces - You got meat on the table"!!!

@Briha, Great saying by your Grandpa!!

[pradeep.kumar]

@ lakecity_shooter : Can you post the picture please. What scope is that?

Here is an additional information I found in "target-tune dot in" website and it was a pleasant shock for me.
They have a re-modeled power factory for IHP called "IHP35 Receiver set" you may want to give it a try.

[lakecity_shooter]

@ mundaire and brihacharan ji....thanks for throwing light on the subject.

I have this IHP for more than 10 years i guess and it still shoots straight. But expectations dont die so i am from quite a time finding a way to increase the velocity without compromising with the accuracy.its a old ihp with vanished bluing however it shoots great .in the night i sometimes check the airgun's range and i try to hit a electric pole from my hotel's terrace and believe me that "TANN" sound never lies.which make me love my ihp more and more .the approximate distance from my terrace to that pole is around 70 yards...i try to shoot in no wind condition to hear that .
@pradeep.... Thank you for the information and please guide me if u can about how to post pictures on the forum as i never did it before....and once again a big thanks to brihacharan ji for the informative pm he sent...just for information i completely removed the front and rear sight from the air rifle.

[pratik_mahale]

Does any one used "IHP35 Receiver set” by Target Tune

[mercury]

lakecity_shooter.....just as a comparitve/ reference for my own interest....

at what range have you zero-ed the rifle ?? and are you able to see how much below your point of aim ( at the pole) does the pellet acctually hit the pole??

used to shoot at the old steel electric poles that were on the farm....very addictive; and there is a very distintive sound when hit dead centre!!

shoot safe

[lakecity_shooter]

@mercury....i zeroed my ihp at 25 yards using benchrest position..........and i am sorry as i told i shot at the pole in the night as in the day there are peaple around ...its kinda unsafe......i think u want a idea about the drop of the pellet....if that is the case i am sorry....... as if u align ur sights correctly on a 50 feet tall pole in no wind ..u will hit the pole for sure........i dont mean to preach you.. i can say confidently that after installing the scope i have improved a lot in my shooting skills..........

[mercury]

thanks lakecity_shooter ; yes i was trying to get an idea of pellet drop based on your zero. but then of course the weight of the pellet is also neccessary....any way thanks.

yes a scope does help to shoot in low light. but....

shoot safe.

[namcmd]

70 yards = 64.00800 meters with IHP

[lakecity_shooter]

64.00800 meters with IHP.if u have a ihp.please try the same distance on a 50 foot long pole in no wind. all ur doubts would be over then.....